Planet SGS-6341 Series Command Manual page 677

Global mode
Usage Guide:
Enable BGP by specified AS, and then enter the config-router state, the protocol can be configured
at this prompt.
Example:
Enable BGP, AS number is 4294967295 in decimal notation.
Switch(config)#router bgp 4294967295
Switch(config-router)#exit
Enable BGP, AS number is 4294967295 in delimiter method.
Switch(config)#router bgp 65535.65535
Switch(config-router)#exit
37.87 set vpnv4 next-hop
Command:
set vpnv4 next-hop <ip-addr>
no set vpnv4 next-hop <ip-addr>
Function:
Configure the nexthop of the VPNv4 route.
Parameter:
<ip-addr> is nexthop of VPNv4 route.
Command Mode:
VRF mode
Usage Guide:
Configure VPNv4 route nexthop with this command. As normal nexthop settings are only for IPv4
route, this command specially configures the VPNv4 address-family.
Example:
Configure the address-family as follows:
Switch(config)#route-map map1 permit 15
Switch(config-map)#match interface Vlan1
Switch(config-map)#set weight 655
Switch(config-map)#set vpnv4 next-hop 10.1.1.250
Switch(config-map)#exit
Switch(config)#router bgp 100
Switch(config-router)#neighbor 10.1.1.68 remote-as 100
37-316