Planet SGS-6341 Series Command Manual page 978

no dot1x timeout tx-period
Function:
Sets the interval for the supplicant to re-transmit EAP request/identity frame; the "no dot1x timeout
tx-period" command restores the default setting.
Parameters:
<seconds> is the interval for re-transmission of EAP request frames, in seconds; the valid range is
1 to 65535.
Command mode:
Global Mode.
Default:
The default value is 30 seconds.
Usage Guide:
Default value is recommended.
Example:
Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200
48.23 dot1x unicast enable
Command:
dot1x unicast enable
no dot1x unicast enable
Function:
Enable the 802.1x unicast passthrough function of switch; the no operation of this command will
disable this function.
Command mode:
Global Configuration Mode.
Default:
The 802.1x unicast passthrough function is not enabled in global mode.
Usage Guide:
The 802.1x unicast passthrough authentication for the switch must be enabled first to enable the
802.1x unicast passthrough function, then the 802.1x function is configured.
Example:
Enabling the 802.1x unicast passthrough function of the switch and enable the 802.1x for port 1/0/1.
Switch(config)#dot1x enable
Switch(config)# dot1x unicast enable
48-15