Test Media Server 1 Leds - Avaya S8700 Installing Manual

Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Under Diagnostics click Execute Ping.
4
Type in the IP address of a computer on the network.
5
6 Click Execute Ping.
Verify that the ping was successful, indicating that the media server is connected to the
7
customer's network.
8 Type in the host name, if DNS is administered, of a computer on the network.
Click Execute Ping.
9
10 Verify that the ping was successful, indicating that DNS is working.
If available, have a customer representative do the following test from a computer on their
network:
Click Start > Run to open the Run dialog box.
11
12 Type command to open an MS-DOS command window.
Type ping server1ipaddress, where server1ipaddress is the IP address of media server 1.
13
14 Verify that the ping was successful.
15 Type ping server1name, where server1name is the host name of media server 1, if DNS
is administered.
16 Verify that the ping was successful.

Test media server 1 LEDs

1 Under Diagnostics click Test Server LEDs to test the media server LEDs.
Observe the Active/Standby and U2 LEDs on the front of the media server and the
2
transmit LED on the duplication card on the back of the media server to ensure they are
blinking. The blinking stops after about a minute.
See ''S8700 Media Server LEDs'' on page 251 for more specific information.
May 2003
Configure Media Server 1
37