ABB RELION Series Technical Manual page 54

Section 3
Basic functions
48
Warnings are indicated with the text Warning additionally provided with the name
of the warning, a numeric code and the date and time on the LHMI. The warning
indication message can be manually cleared.
If a warning appears, record the name and code so that it can be
provided to ABB customer service.
Table 7: Warning indications and codes
Warning indication
Warning
Watchdog reset
Warning
Power down det.
Warning
IEC61850 error
Warning
Modbus error
Warning
DNP3 error
Warning
Dataset error
Warning
Report cont. error
Warning
GOOSE contr. error
Warning
SCL config error
Warning
Logic error
Warning
SMT logic error
Warning
GOOSE input error
ACT error
Warning
GOOSE Rx. error
Warning
AFL error
Warning
SMV config error
Warning
Comm. channel down
Warning
Unack card comp.
Warning
Protection comm.
Warning
ARC1 cont. light
Table continues on next page
Warning code Additional information
10 A watchdog reset has occurred.
11 The auxiliary supply voltage has dropped
too low.
20 Error when building the IEC 61850 data
model.
21 Error in the Modbus communication.
22 Error in the DNP3 communication.
24 Error in the Data set(s).
25 Error in the Report control block(s).
26 Error in the GOOSE control block(s).
27 Error in the SCL configuration file or the file
is missing.
28 Too many connections in the
configuration.
29 Error in the SMT connections.
30 Error in the GOOSE connections.
31 Error in the ACT connections.
32 Error in the GOOSE message receiving.
33 Analog channel configuration error.
34 Error in the SMV configuration.
35 Redundant Ethernet (HSR/PRP)
communication interrupted.
40 A new composition has not been
acknowledged/accepted.
50 Error in protection communication.
85 A continuous light has been detected on
the ARC light input 1.
1MRS758755 A
REC615 and RER615
Technical Manual