Signals - ABB RELION Series Technical Manual

Section 3
Basic functions
3.16.14.4
172
When the Operation mode is set to "Pulsed", the corresponding output can be used to
produce the predefined length of pulses. Once activated, the output remains active for
the duration of the set pulse length. When activated, the additional activation
command does not extend the length of pulse. Thus, the pulse needs to be ended before
the new activation can occur.
The Description setting can be used for storing signal names for each output.
Each control point or SPCLGAPC can only be accessed through the LHMI control.
SPCLGAPC follows the local or remote (L/R) state if the Loc Rem restriction setting
is "true". If the Loc Rem restriction setting is "false", local or remote (L/R) state is
ignored, that is, all controls are allowed regardless of the local or remote state.
The BLOCK input can be used for blocking the output functionality. The BLOCK input
operation depends on the Operation mode setting. If the Operation mode setting is set
to "Toggle", the output state cannot be changed when the input BLOCK is TRUE. If the
Operation mode setting is set to "Pulsed", the activation of the BLOCK input resets the
output to the FALSE state.

Signals

Table 182: SPCLGAPC Input signals
Name Type
BLOCK BOOLEAN
Table 183: SPCLGAPC Output signals
Name Type
O1 BOOLEAN
O2 BOOLEAN
O3 BOOLEAN
O4 BOOLEAN
O5 BOOLEAN
O6 BOOLEAN
O7 BOOLEAN
O8 BOOLEAN
O9 BOOLEAN
O10 BOOLEAN
O11 BOOLEAN
O12 BOOLEAN
O13 BOOLEAN
O14 BOOLEAN
O15 BOOLEAN
O16 BOOLEAN
Default Description
0=False Block signal for activating the blocking mode
Description
Output 1 status
Output 2 status
Output 3 status
Output 4 status
Output 5 status
Output 6 status
Output 7 status
Output 8 status
Output 9 status
Output 10 status
Output 11 status
Output 12 status
Output 13 status
Output 14 status
Output 15 status
Output 16 status
1MRS758755 A
REC615 and RER615
Technical Manual