ABB RELION Series Technical Manual page 250

Section 4
Protection functions
Parameter
Voltage Mem time
Directional mode
Characteristic angle
Pol quantity
Table 251: FDPHLPDOC Group settings (Advanced)
Parameter
Start value Mult
Time multiplier
Type of reset curve
Max forward angle
Max reverse angle
Min forward angle
Min reverse angle
Table 252: FDPHLPDOC Non group settings (Basic)
Parameter
Operation
Num of start phases
Curve parameter A
Curve parameter B
Curve parameter C
Curve parameter D
Curve parameter E
Allow Non Dir
244
Values (Range) Unit
0...3000 ms
1=Non-directional
2=Forward
3=Reverse
-179...180 deg
1=Self pol
4=Neg. seq. volt.
5=Cross pol
7=Pos. seq. volt.
Values (Range) Unit
0.8...10.0
0.05...15.00
1=Immediate
2=Def time reset
3=Inverse reset
0...90 deg
0...90 deg
0...90 deg
0...90 deg
Values (Range) Unit
1=on
5=off
1=1 out of 3
2=2 out of 3
3=3 out of 3
0.0086...120.0000
0.0000...0.7120
0.02...2.00
0.46...30.00
0.0...1.0
0=False
1=True
Step Default
1 40
2=Forward
1 60
5=Cross pol
Step Default
0.1 1.0
0.01 1.00
1=Immediate
1 80
1 80
1 80
1 80
Step Default
1=on
1=1 out of 3
1 28.2000
1 0.1217
1 2.00
1 29.10
1 1.0
0=False
1MRS758755 A
Description
Voltage memory time
Directional mode
Characteristic angle
Reference quantity used to determine
fault direction
Description
Multiplier for scaling the start value
Time multiplier in IEC/ANSI IDMT curves
Selection of reset curve type
Maximum phase angle in forward
direction
Maximum phase angle in reverse
direction
Minimum phase angle in forward direction
Minimum phase angle in reverse direction
Description
Operation Off / On
Number of phases required for operate
activation
Parameter A for customer programmable
curve
Parameter B for customer programmable
curve
Parameter C for customer programmable
curve
Parameter D for customer programmable
curve
Parameter E for customer programmable
curve
Allows prot activation as non-dir when dir
info is invalid
REC615 and RER615
Technical Manual