Setting Guidelines; Single Point Generic Control 8 Signals Spc8Gapc; Identification; Application - ABB Relion SAM600 Applications Manual

1MRK 511 445-UEN B
Refer to Table
the quality attributes.
Table 4:
VALID
0
3.4.3

Setting guidelines

The function does not have any parameters available in the PCM600.
3.5

Single point generic control 8 signals SPC8GAPC

3.5.1

Identification

Function description
Single point generic control 8 signals
3.5.2

Application

The Single point generic control 8 signals (SPC8GAPC) function block is a collection of 8 single
point commands that can be used for direct commands for example putting IED in
"ChangeLock" state from remote. In this way, simple commands can be sent directly to the IED
outputs, without confirmation. Confirmation (status) of the result of the commands is
supposed to be achieved by other means, such as binary inputs and SPGAPC function blocks.
3.5.3 Setting guidelines
The parameters for the single point generic control 8 signals (SPC8GAPC) function are set via
PCM600.
Operation : turning the function operation On / Off .
There are two settings for every command output (totally 8):
PulseModex : decides if the command signal for output x is Latched (steady) or Pulsed .
Switchgear control unit SAM600-IO
Application manual
4 for the description of the input-output relationship in terms of the value and
Description of the input-output relationship
OPEN
-
1 0
1 1
1 0
1 1
PSTO is the universal operator place selector for all control functions. Even if
PSTO can be configured to allow LOCAL or ALL operator positions, the only
functional position usable with the SPC8GAPC function block is REMOTE.
© Copyright 2017 ABB. All rights reserved
CLOSE
-
0
0
1
1
IEC 61850 IEC 60617
identification identification
SPC8GAPC -
POSITION
Value Description
0 Intermediate
0 Intermediate
1 Open
2 Closed
3 Bad State
ANSI/IEEE C37.2
device number
-
Section 3
Control
SEMOD55398-5 v5
SEMOD176448-1 v3
SEMOD176456-2 v3
SEMOD176511-4 v7
SEMOD176518-4 v7
25