Settings (Oem Area); 20.7.14 Program Execution - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

20.7.13 Settings (OEM area)

Path:
Parameters
Application
Override display
Keyboard theme
Program run
Text database
Messages

20.7.14 Program execution

Path:
Parameter
Automatic advance on reaching
upper spindle sleeve final
position
M functions
354
Settings ► Service ► OEM area ► Settings
Settings ► Service ► OEM area ► Settings ► Program run
Explanation
The type of application mode; a change does not become active
until a restart is performed
Settings:
Milling
Turning
Default value: Milling
Type of override display in Manual mode and MDI
Settings:
Percent: Override is displayed in percent of the set maximum
feed rate
Value: Override is displayed in mm/min
Default value: Percent
Selection of the keyboard layout
Settings:
Standard: entry confirmed with (Return)
TNC: entry confirmed with (Enter)
Default value: Standard
Modifying of the program execution
Further information: "Program execution", Page 354
Text database with message texts that are used for OEM-specif-
ic messages
Further information: "Text database", Page 355
Definition of OEM-specific messages
Further information: "Messages", Page 355
Explanation
Automatic advance when executing hole patterns always occurs
when the upper spindle sleeve limit switch is reached
Settings: ON or OFF
Default value: OFF
For the configuration, see "Configuring M functions", Page 356
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | Service