Adjusting Settings In The Quick Access Menu - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

6
Operating
element
6.10.2

Adjusting settings in the quick access menu

With the quick access menu, you can adjust the following settings:
Unit for linear values (Millimeters or Inch
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
The display of Radial machining axes (Radius or Diameter)
The Scaling factor by which the stored position is multiplied during execution
of an MDI block or program block
Feed-rate value for axes in the Manual operation and MDI operating modes
Setting the units of measure
Activating the display of Radial machining axes
X
94
Function
Override
Display of the changed traversing speed of an axis. The
change is made using an external controller on an NC-
controlled machine tool
Auxiliary functions
Auxiliary functions in Manual operation mode, depending
on the configured application mode
Further information: "Auxiliary functions in Manual
operation mode", Page 97
MDI block
For creating machining blocks in MDI mode
Tap the quick access menu on the status bar
Select the desired Unit for linear values
Select the desired Unit for angular values
Tap Close to close the quick access menu
The selected units are displayed in the quick access menu
Tap the quick access menu on the status bar
Select the desired option
Tap Close to close the quick access menu
If the Diameter option is selected, then the corresponding
icon appears in the position display
Basic operation | Status bar
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018