Settings | Interfaces
USB
20.4.3
Settings ► Interfaces ► USB
Path:
Parameter
Automatically detect attached
USB mass storage devices
20.4.4
Axes (switching functions)
Settings ► Interfaces ► Switching functions ► Axes
Path:
In the Manual operation and MDI modes of operation, all axes or individual axes
can be reset to zero by setting the assigned digital input.
Not all of the described parameters and options may be available,
depending on the product version, configuration and the connected
encoders.
Parameter
General settings
X
Y
Z
...
Position-dependent switching functions
20.4.5
Settings ► Interfaces ► Position-dependent switching functions ► +
Path:
The position-dependent switching functions enable you to set logical outputs
depending on the position of an axis in a defined reference system. Switching
positions and position intervals are available for this.
Not all of the described parameters and options may be available,
depending on the product version, configuration and the connected
encoders.
Parameter
Name
Switching function
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Explanation
Automatic recognition of a USB mass storage device
Settings: ON or OFF
Default setting: ON
Explanation
Assignment of the digital input according to pin layout to zero
reset all axes
Default setting: Not connected
Assignment of the digital input according to pin layout to reset
the axis to zero
Default setting: Not connected
Explanation
Name of the switching function
Selecting whether the switching function should be activated or
deactivated
Settings: ON or OFF
Default setting: ON
20
317