Managing Programs; Opening A Program; Closing A Program; Saving A Program - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Milling – Programming | Managing programs
17.5

Managing programs

After you have created a program, you can save it for automatic program run or
subsequent editing.
The default storage location for programs is Internal/Programs.
17.5.1

Opening a program

17.5.2

Closing a program

17.5.3

Saving a program

17.5.4

Saving the program under a new name

17.5.5

Saving the program automatically

HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Tap Open program in the program management
Select the storage location in the dialog, e.g.
Internal/Programs
Tap the folder containing the file
Tap the file
Tap Open
The selected program is loaded
Tap Close program in the program management
The opened program is closed
Tap Save program in the program management
The program is saved
Tap Save program as in the program management
In the dialog select the storage location, e.g.
Internal/Programs, in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Save as
The program is saved
The name of the program is displayed on the toolbar
Tap Save program automatically in the program
management
All changes to the program will be automatically saved
immediately
17
279