Coordinate Systems; Machine Functions - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

17
17.2.2

Coordinate systems

To change a coordinate system, you can call presets from the preset table. The
coordinate system of the selected preset will then be used after the call.
Further information:
Preset block
Parameter
Preset number
17.2.3

Machine functions

You can call machine functions to machine the workpiece.
The available functions depend on the configuration of the connected machine
tool. The following blocks and parameters are available:
Block type
Spindle speed
Feed rate
Tool call
M function
Dwell time
272
"Defining presets", Page 214
Description
ID from the preset table
Optional: Selection from preset table
Parameter / Description
Rotational speed of the tool spindle
Traversing speed of the tool axis (only for NC-controlled
Z axis)
Number of the tool
Optional: Selection from tool table
Further information:
When a tool call is run, the spindle is automatically
stopped and the user is requested to load the corre-
sponding tool.
Number of the M function
Optional: Selection from function table
Time interval between machining steps
Milling – Programming | Block types
"Selecting a tool", Page 219
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018