Programming The Tool; Programming The Row Of Holes - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

9
9.9.4

Programming the tool

9.9.5

Programming the row of holes

194
Milling – Quick Start | Programming a bolt hole circle and row of holes (programming)
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Tool call block
type
Tap Tool number
The Tools dialog appears
Tap Drill 5.0
The associated tool parameters are applied automatically
The Tools dialog is closed
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Spindle speed
block type
In Spindle speed, enter the value 3000
Confirm the entry with RET
Tap Add block on the toolbar
A new block is inserted below the current position
Select the Row of holes block type in the Block type drop-
down list
Enter the following values:
X coordinate of 1st hole: -90
Y coordinate of 1st hole: -45
Holes per row: 4
Hole spacing: 45
Angle: 0°
Depth: -13
Number of rows: 3
Row spacing: 45
Fill mode: frame of holes
If the tool axis is NC-controlled, additionally enter the
following parameters:
Clearance height: 10
Feed rate: 2000
Feed rate for plunging: 600
Confirm each entry with RET
Tap Save program in the program management
The program is saved
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018