Inputs (S) - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

20.6.23 Inputs (S)

Path:
Parameters
Enable digital movement
commands
Spindle start
Spindle stop
Digital enable inputs
Spindle ready
Spindle interrupt
Spindle protection device
Spindle sleeve final position +
Spindle sleeve final position –
344
The switching functions are available only for units with ID number
1089177-xx.
Settings ► Axes ► S ► Inputs
Explanation
Use of the digital movement commands
Settings: ON or OFF
Default value: OFF
Assignment of the digital input for the spindle start according to
pin layout
Default value: Not connected
Assignment of the digital input for the spindle stop according to
pin layout
Default value: Not connected
Configuration of the digital inputs for the spindle enable
Assignment of a digital input; indicates that the spindle is in
reliable condition
Default value: Not connected
Assignment of a digital input; in active state it immediately
disconnects from power the configured analog output of the
spindle. A spindle movement is stopped without a ramp, axes
with automatic traverse are stopped if applicable and spindle
activation is prevented.
The machine tool builder is responsible for the
immediate stopping of the spindles.
Default value: Not connected
Assignment of a digital input; indicates whether an existing
spindle protection device is open or closed. This signal influ-
ences error messages and program run.
The machine tool builder is responsible for the
immediate shutdown of the spindles with opened
spindle protection.
Default value: Not connected
Assignment of a digital input for the upper limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting.
Default value: Not connected
Assignment of a digital input for the lower limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting.
Default value: Not connected
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | Axes