Proceeding To A Specific Program Block; Aborting The Program Run; Using The Simulation Window - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

16
16.2.2

Proceeding to a specific program block

To go to a specific block, you can skip blocks one by one within a program until you
reach the desired block. It is not possible to jump back in the program.
16.2.3

Aborting the program run

If errors or problems occur, you can abort the execution of a program. The tool
position and the spindle speed remain unchanged when the program run is
aborted.
16.2.4

Using the simulation window

You can display a visualization of the selected block in the optional simulation
window.
The following options are available on the view bar:
Operating element
264
Tap Next program step on the program control
The next block is selected
The program run cannot be aborted if the current block is executing a
traverse motion.
Tap Stop program in the program management
The program run is aborted
Function
Graphic
Display of simulation and blocks
Graphic-Position
Display of simulation, position values and blocks
Position
Display of position values and blocks
Turning – Program run | Using the program
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018