Simulating The Program Run - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Milling – Quick Start | Programming a bolt hole circle and row of holes (programming)
9.9.6

Simulating the program run

After successfully programming the bolt hole circle and row of holes you can then
simulate the sequence of the program created with the simulation window.
Figure 43: Example workpiece – simulation window
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Tap Simulation window
The simulation window is displayed
Tap each program block, one after the other
The tapped machining step is shown in color in the
simulation window
Check the view for programming errors, e.g. tool path
intersections of holes
If there are no programming errors you can machine the bolt
hole circle and row of holes
9
195