Selecting A Tool - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Turning – Manual operation | Selecting a tool
12.6

Selecting a tool

The currently selected tool is displayed on the status bar. Here you can also access
the tool table where you can select the tool you want to use. The associated tool
parameters are applied automatically.
The setup engineer (Setup) may have already made the settings in the
tool table.
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
"Creating a tool table", Page 164
Tap Tools on the status bar
The Tools dialog appears
Tap the tool you want to use
Tap Confirm
The associated tool parameters are applied automatically
The selected tool is shown on the status bar
Mount the desired tool on the machine tool
12
227