Sensors; Touch Probe - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

Sensors

20.3
This chapter describes settings for configuring the sensors.

Touch probe

20.3.1
Path:
Parameters
Touch probe
Always use touch probe for
probing
Length
Diameter
314
The following information applies only to the Milling application mode.
Settings ► Sensors ► Touch probe
Explanation
Selection of the edge finder
Settings:
NONE
KT 130
Default value: NONE
Definition whether the edge finder should always be used for
probing
Setting range: ON or OFF
Default setting: OFF
Length offset of the edge finder
Setting range: ≥ 0.0001
Default value: 0.0000
Diameter of the edge finder
Setting range: ≥ 0.0001
Default value for selection of KT 130: 6.0000
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | Sensors