Block Types; Positioning - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Milling – Programming | Block types
17.2

Block types

You can use the following block types for programming:
Positioning functions
Change of coordinate system (preset)
Machine functions
Machining patterns
17.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
You can load the current axis position with Actual position capture into
the appropriate input fields.
The following parameters are available:
Positioning block
Parameter
R0
R+
R–
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Drilling through without position value specification
(only for manually operated Z axis)
17
271