Deleting A Program; Running Program Blocks - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

18
18.5.6

Deleting a program

18.6

Running program blocks

You can make later changes to any block of a program. To apply the changes to the
program, you need to save the program again after you have made the changes.
Editing program blocks
292
Tap Delete the program in the program management
Tap Delete selection
Tap OK to confirm deletion
The program is deleted
Tap Open program in the program management
Select the storage location in the dialog,
e.g. Internal/Programs
Tap the folder containing the file
Tap the file
Tap Open
The selected program is loaded
Tap the desired block
The parameters of the selected block are displayed
Edit the relevant parameters, depending on the block type
Confirm each entry with RET
Tap Save program in the program management
The edited program is saved
Turning – Programming | Managing programs
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018