HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 256

15
Depiction as contour view
The simulation window displays a contour view. The contour view provides the
necessary feedback for precisely positioning the tool or for following a contour
along the machining plane.
The contour view uses the following colors (defaults):
Figure 72: Simulation window with contour view
1 Machining pattern (white)
2 Current block or machining position (green)
3 Tool contour, tool position and tool path (orange)
256
You can modify the colors and line thicknesses used in the contour
view.
Further information: "Simulation window", Page 307
Milling – Program run | Using the program
1
2
3
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018