20.2.12 Units - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

20.2.12 Units

Path:
Parameter
Unit for linear values
Rounding method for linear
values
Decimal places for linear values
Unit for angular values
Rounding method for angular
values
312
Settings ► General ► Units
Explanation
Unit of measure for linear values
Settings: Millimeters or Inch
Default setting: Millimeters
Rounding method for linear values
Settings:
Commercial: Decimal places from 1 to 4 are rounded down,
decimal places from 5 to 9 are rounded up
Round off: Decimal places from 1 to 9 are rounded down
Round up: Decimal places from 1 to 9 are rounded up
Truncate: Decimal places are truncated without rounding up
or down
Round to 0 and 5: Decimal places ≤ 24 or ≥ 75 are rounded
to 0, decimal places ≥ 25 or ≤ 74 are rounded to 5
Default setting: Commercial
Number of decimal places for linear values
Setting range:
Millimeters: 0 ... 5
Inch: 0 ... 7
Default value:
Millimeters: 4
Inch: 6
Unit for angular values
Settings:
Radian: angles in radian (rad)
Decimal degrees: angles in degrees (°) with decimal places
Deg-Min-Sec: angles in degrees (°), minutes ['] and
seconds ["]
Default setting: Decimal degrees
Rounding method for decimal angular values
Settings:
Commercial: Decimal places from 1 to 4 are rounded down,
decimal places from 5 to 9 are rounded up
Round off: Decimal places from 1 to 9 are rounded down
Round up: Decimal places from 1 to 9 are rounded up
Truncate: Decimal places are truncated without rounding up
or down
Round to 0 and 5: Decimal places ≤ 24 or ≥ 75 are rounded
to 0, decimal places ≥ 25 or ≤ 74 are rounded to 5
Default setting: Commercial
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | General