20.6.12 Encoder - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

20.6.12 Encoder

Settings ► Axes ► X, Y ... ► Encoder
Path:
Settings for encoders with interfaces of the EnDat 2.2 type
Parameter
Encoder input
Interface
Identification label
Diagnosis
Encoder model
Mechanical ratio
Reference point displacement
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Explanation
Assignment of the encoder input to the axis of the product
Settings:
Not connected
X1
X2
X3
X4
X5
X6
Further information: "Product overview", Page 50
Automatically detected EnDat interface type
Information about the encoder that was read out from the
electronic ID label
Results of encoder diagnostics
Connected encoder model
Settings:
Linear encoder: linear axis
Angle encoder: rotary axis
Angle encoder as linear encoder: rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
For display of a rotary axis as a linear axis:
traverse path in mm per revolution
Setting range: 0.1 mm ... 1000 mm
Default value: 1.0
Configuration of the offset between the reference mark and the
zero point
Further information: "Reference point displacement",
Page 337
20
333