Creating A Program Header; Adding Blocks; Deleting Blocks; Saving A Program - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Milling – Programming | Creating a program
17.3.2

Creating a program header

17.3.3

Adding blocks

17.3.4

Deleting blocks

17.3.5

Saving a program

HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Tap Create new program in the program management
In the dialog select the storage location, e.g.
Internal/Programs, in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Create
A new program containing the Program header start block is
created
The name of the program is displayed on the toolbar
Enter a unique name in the Name field
Confirm the entry with RET
Change the unit of measure with the slide switch, if required
Tap Add block on the toolbar
A new block is inserted below the current position
Select the desired block type in the Block type drop-down
list
Define the relevant parameters, depending on the block type
Further information: "Block types", Page 271
Confirm each entry with RET
If the simulation window is active, the current block is
visualized
Tap Delete on the toolbar
The blocks contained in the program are marked with a
Delete symbol
Tap the Delete symbol for the blocks you want to delete in
the program
The selected blocks are deleted from the program
Tap Delete on the toolbar again
Tap Save program in the program management
The program is saved
17
275