HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 167

Setup | Single steps for setup
Deleting a tool
Milling application mode
Turning application mode
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Tap Tools on the status bar
The Tools dialog appears
Tap Tools on the status bar
The Tools dialog appears
Tap Open table
The Tool table dialog appears
To select one or more tools, tap the checkbox in the relevant
row
The active checkbox is highlighted in green
The entry for a tool can be locked to prevent
accidental changes or deletion.
Tap the Unlock symbol next to the entry
The symbol changes and the entry is unlocked
Tap Delete
A message appears
Close the message with OK
The selected tool is deleted from the tool table
Tap Close
The Tool table dialog is closed
8
167