Outputs (S) - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

20.6.22 Outputs (S)

The switching functions are available only for units with ID number
1089177-xx.
Settings ► Axes ► S ► Outputs
Path:
Parameters
Analog output
Analog output is inverted
Smax
Umax
Enable spindle CW
Enable spindle CCW
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Explanation
Assignment of the analog output according to pin layout
Default value: Not connected
If this function is active, the analog signal is inverted at the
output
Default value: not active
Definition of the Spindle speed attained with Umax
Setting range: 100 rpm ... 10000 rpm
Default value: 2000
The Maximum machine speed cannot be exceeded,
even if a higher feed rate has been defined for
individual axes.
Further information: "Special settings", Page 330
Maximum voltage that is output at the analog output in order to
attain Smax
Setting range: 1000 mV ... 10000 mV
Default value: 9000
Assignment of the digital output for the clockwise spindle enable
according to pin layout
Default value: Not connected
Assignment of the digital output for the counterclockwise
spindle enable according to pin layout
Default value: Not connected
20
343