HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 233

Milling – MDI mode | Block types
Row of holes block
Z
Figure 57: Schematic display of the row of holes block
Parameter
X coordinate of 1st
hole
Y coordinate of 1st
hole
Holes per row
Hole spacing
Angle
Depth
Number of rows
Row spacing
Fill mode
Clearance height
Feed rate
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Description
1st hole of the linear hole pattern in the X plane
1st hole of the linear hole pattern in the Y plane
Number of holes per row
Spacing or offset between the individual holes of a row
Rotation angle of the row of holes
Target depth for drilling in the Z plane
Default: Drilling through-holes (not available for NC-
controlled Z axis)
Number of rows of holes in the linear hole pattern
Spacing between the individual rows of holes
Distribution of holes
All holes
Frame of holes
Starting depth for milling in the tool axis (only for NC-
controlled Z axis)
Traversing speed of the tool axis (only for NC-controlled
Z axis)
13
233