20.6.20 Software Limit Switches; 20.6.21 Spindle Axis S - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

20.6.20 Software limit switches

Settings ► Axes ► X, Y ... ► Software limit switches
Path:
Parameters
Software limit switches
Limit switch in positive direction
Limit switch in negative
direction

20.6.21 Spindle axis S

The switching functions are available only for units with ID number
1089177-xx.
Settings ► Axes ► Spindle axis S
Path:
Parameters
Axis name
Axis type
Outputs
Inputs
Gear stages
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Explanation
Use of the software limit switch
Settings: ON or OFF
Default value: OFF
Distance (in mm) in the positive direction from the machine zero
point to the software limit switch (including Reference point
displacement, if activated)
Default value: 0
Distance (in mm) in the negative direction from the machine zero
point to the software limit switch (including Reference point
displacement, if activated)
Default value: 0
Explanation
Definition of the axis name displayed in the position preview
Settings:
Not defined
S
Default setting: S
Definition of the axis type
Settings:
Not defined
Linear axis
Spindle
Gear spindle
Default setting: Spindle
Configuration of the Outputs for the spindle
Further information: "Outputs (S)", Page 343
Configuration of the Inputs for the spindle
Further information: "Inputs (S)", Page 344
Configuration of the Gear stages for the Gear spindle
Further information: "Configuring Gear stages", Page 345
20
341