HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 117

Commissioning | Steps for commissioning
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
If the linear encoder has coded reference marks, enter the
Maximum traverse path (see Page 118)
If the angle encoder has coded reference marks, enter the
parameter for the Nominal increment (see Page 118)
Confirm the entry with RET
Use the ON/OFF sliding switch to activate or deactivate
Inversion of reference mark pulses
Tap Reference point displacement
Use the ON/OFF slide switch to activate or deactivate
Reference point displacement (calculation of the offset
between the reference mark and the machine zero point)
If activated, enter the offset value for Reference point
displacement
Confirm the entry with RET
As an alternative, you can tap Apply in Current position for
reference point shift in order to apply the current position
as the offset value
In order to switch to the previous display, tap Back twice
In the Analog filter frequency drop-down list, select
the frequency of the low-pass filter for suppressing high-
frequency interference signals:
33 kHz: Interference frequencies above 33 kHz
400 kHz: Interference frequencies above 400 kHz
Use the ON/OFF sliding switch to activate or deactivate the
Terminating resistor
The terminating resistor is automatically deactivated
for incremental signals of the current signal type
(11 μA
)
PP
Select the type of error monitoring in the Error monitor
drop-down list:
Off: Error monitoring not active
Amplitude: Error monitoring of signal amplitude
Frequency: Error monitoring of signal frequency
Frequency & amplitude: Error monitoring of signal
amplitude and signal frequency
Select the desired counting direction in the Counting
direction drop-down list:
Positive: The direction of traverse is in the counting
direction of the encoder
Negative: The direction of traverse is opposite to the
counting direction of the encoder
"Axes X, Y ...", Page 331
7
117