Wiring Switching Inputs And Outputs - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

5
5.6

Wiring switching inputs and outputs

Hazard when using switching inputs for safety functions!
If switching inputs for mechanical limit switches are used for safety functions,
severe injury or death can result.
Do not use the switching inputs for mechanical limit switches for safety
functions
Wire switching inputs and outputs in accordance with the following pin layout
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information:
Connect the connecting cables of the peripherals tightly to their connectors
Further information:
If the cable connectors include mounting screws, do not overtighten them
54
Depending on the peripherals to be connected, the connection work
may need to be carried out by an electrical specialist.
Example: Safety Extra Low Voltage (SELV) exceeded
Further information: "Personnel qualification", Page 31
The product fulfills the requirements of standard IEC 61010-1 only if the
power to the peripheral devices is supplied from a secondary circuit
with current limitation as per IEC 61010-1
power limitation as per IEC 60950-1
secondary circuit as specified in UL1310.
In place of IEC 61010-1 3rd Ed.
of standards DIN EN 61010-1, EN 61010-1, UL 61010-1 and CAN/CSA-
C22.2 No. 61010-1can be used, and, in place of IEC 60950-1
Section 2.5, the corresponding sections of standards DIN EN 60950-1,
EN 60950-1, UL 60950-1, CAN/CSA-C22.2 No. 60950-1 can be applied.
"Assembly of the product", Page 42
"Product overview", Page 50
The digital or analog inputs and outputs must be assigned in the device
settings of the respective switching function.
Installation | Wiring switching inputs and outputs
WARNING
3rd Ed. , Section 9.4 or with
2nd Ed. , Section 2.5 or from a Class 2
, Section 9.4, the corresponding sections
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
2nd Ed. ,