Adding A Tool - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

12
12.5

Adding a tool

In the Manual Operation mode, you can enter the tools you want to use into the
tool table.
A workpiece is clamped on the machine tool
The axes have been homed
Turning application mode
226
The setup engineer (Setup) may have already made the settings in the
tool table.
Further information: "Creating a tool table", Page 164
Tap Tools on the status bar
The Tools dialog appears
Tap Open table
The Tool table dialog appears
Tap Add
Enter a name in the Tool type input field
Confirm the entry with RET
Tap the input fields one after the other, and enter the
corresponding values
Change the unit of measure in the selection menu, if required
The entered values are converted
Confirm the entry with RET
The defined tool is added to the tool table
To protect the entry for a tool from accidental changes or
deletion, tap the Lock symbol next to the tool's entry
The symbol changes and the entry is locked
Tap Close
The Tool table dialog is closed
Turning – Manual operation | Adding a tool
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018