Turning – MDI mode | Applying the Scaling factor
Applying the Scaling factor
14.7
If a scaling factor is activated for one or more axes, this scaling factor is multiplied
by the stored nominal position during execution of a block. This enables you to
mirror and scale a block.
You can activate a scaling factor in the quick access menu.
Further information:
Example:
The following MDI block is programmed:
Figure 69: Example – MDI block
A Scaling factor of -0.5 is activated for the X axis. The following MDI block will
therefore be executed:
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
"Adjusting settings in the quick access menu", Page 94
14
249