20.6.18 Outputs - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

20.6.18 Outputs

Settings ► Axes ► X, Y ... ► Outputs
Path:
Parameters
Analog output
Analog output is inverted
Fmax
Umax
Drive enable
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Explanation
Assignment of the analog output according to pin layout
Default value: Not connected
If this function is active, the analog signal is inverted at the
output
Default value: not active
Definition of the feed rate achieved at Umax
Setting range: 100 mm/min ... 10000 mm/min
Default value: 2000
The Maximum machine speed cannot be exceeded,
even if a higher feed rate has been defined for
individual axes.
Further information: "Special settings", Page 330
Maximum voltage that is output at the analog output in order to
achieve Fmax
Setting range: 1000 mV ... 10000 mV
Default value: 9000
Assignment of the digital output for the drive enable according to
pin layout
Default value: Not connected
20
339