HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 202

10
Tool table
For the example it is presumed that the tools for machining are not yet defined.
You must add in advance all of the tools to be used to the tool table.
Further information:
202
"Creating a tool table", Page 164
Tap Tools on the status bar
The Tools dialog appears
Tap Open table
The Tool table dialog appears
Tap Add
Enter the designation Finishing tool in the Tool type input
field
Confirm the entry with RET
in the X input field
Enter the value 0
Confirm the entry with RET
in the Z input field
Enter the value 0
Confirm the entry with RET
The defined finishing tool is added to the tool table
Repeat this process for the other tools
Tap Close
The Tool table dialog is closed
Turning – Quick Start | Requirements
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018