16.7.12 Document Oem Bar Item; Settings (Oem Area); 16.7.14 Program Execution - HEIDENHAIN ND 7000 Operating Instructions Manual

Settings | Service

16.7.12 Document OEM bar item

Settings ► Service ► OEM area ► OEM bar ► Bar items ► Document
Path:
Parameters
Description
Type
Select a document
Select image for display
Upload image file
Remove bar entry

16.7.13 Settings (OEM area)

Settings ► Service ► OEM area ► Settings
Path:
Parameters
Application
Override display
Keyboard theme
Program run

16.7.14 Program execution

Settings ► Service ► OEM area ► Settings ► Program run
Path:
Parameter
Automatic advance on reaching
upper spindle sleeve final
position
M functions
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Explanation
Description of the bar item on the OEM bar
Document
Selecting the desired document
Selecting the desired image for depicting the function
Copies a selected image file to the storage location /Oem/
Images
Removing the bar item from the OEM bar
Explanation
The type of application mode; a change does not become active
until a restart is performed
Settings:
Milling
Turning
Default value: Milling
The current firmware of the units in this series does
not support this function.
Selection of the keyboard layout
Settings:
Standard: entry confirmed with (Return)
TNC: entry confirmed with (Enter)
Default value: Standard
Modifying of the program execution
Further information: "Program execution", Page 267
Explanation
Automatic advance when executing hole patterns always occurs
when the upper spindle sleeve limit switch is reached
Settings: ON or OFF
Default value: OFF
For the configuration, see "Configuring M functions", Page 269
16
267