Segmented Linear Error Compensation (Slec); 20.6.17 Create Table Of Supporting Points - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

20.6.16 Segmented linear error compensation (SLEC)

Path:
Parameters
Compensation
Table of supporting points
Create table of supporting points

20.6.17 Create table of supporting points

Path:
Parameters
Number of supporting points
Spacing of the supporting points
Start point
Create
338
Settings ► Axes ► X, Y ... ► Error compensation ►
Segmented linear error compensation (SLEC)
Settings ► Axes ► X, Y ... ► Error compensation ►
Segmented linear error compensation (SLEC) ► Create table of supporting points
Explanation
Mechanical influences on the axes of the machine are
compensated
Settings:
ON: Compensation is active
OFF: Compensation is not active
Default value: OFF
When Compensation is active, then the Table of
supporting points cannot be edited or created.
Opens the table of supporting points for manual editing
The menu for creating a new Table of supporting points is
opened
Further information: "Create table of supporting points",
Page 338
Explanation
Number of supporting points on the mechanical axis of the
machine
Setting range: 2 ... 200
Default value: 2
Spacing of the supporting points on the mechanical axis of the
machine
Default value: 100.00000
The start point defines the position starting from which the
compensation is applied to the axis
Default value: 0.00000
Creates a new table of supporting points based on the entries
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | Axes