20.6.11 Axes X, Y - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Axes

20.6.11 Axes X, Y ...

Settings ► Axes ► X, Y ...
Path:
In order to use functions such as the execution of blocks, the
configuration of the axes must comply with the requirements of the
respective application.
Further information:
Parameters
Axis name
Axis type
Encoder
Error compensation
Outputs
Inputs
Software limit switches
Start-up time
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
"Fundamentals of axis configuration", Page 322
Explanation
Selection of the axis name displayed in the position preview
Default setting for the milling application mode: X, Y, Z
Standard setting for the turning application mode: Not defined
In the turning application mode, you can define no
more than the following axes: X, Z, Zo, C, S.
The axis name S will be available for selection after
you have selected the option Spindle or Gear spindle
in axis type.
Definition of the axis type
Settings:
Not defined
Linear axis
Linear axis + NC (possible for up to three axes)
Spindle
Gear spindle
Default setting: Linear axis
Configuration of the connected encoder
Further information:
Configuration of the linear error compensation LEC or segment-
ed linear error compensation SLEC
Further information:
Page 337
Further information:
(SLEC)", Page 338
Configuration of the Outputs for the NC function
Further information:
Configuration of the Inputs for the NC function
Further information:
Configuration of the Software limit switches
Further information:
Definition of the required Start-up time until Fmax is reached
Setting range: 50 ms ... 10000 ms
Default value: 500
"Encoder", Page 333
"Linear error compensation (LEC)",
"Segmented linear error compensation
"Outputs", Page 339
"Inputs", Page 340
"Software limit switches", Page 341
20
331