Overview; Assembly Of The Product - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

4
4.1

Overview

This chapter describes the mounting of the product. It contains instructions about
how to correctly mount the product on stands or holders.
4.2

Assembly of the product

General mounting information
The mount for the mounting variants is provided on the rear panel. The connection
is compatible with the VESA standard 100 mm x 100 mm.
Figure 1: Dimensions of the rear panel
The material for attachment of the mounting variants on the device is included in
delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Allen key, size 2.5 (Duo-Pos stand)
Material for mounting on supporting surface
42
The following steps must be performed only by qualified personnel.
Further information: "Personnel qualification", Page 31
The unit must be mounted to a stand or a holder to ensure the correct
and intended use of the product.
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Mounting | Overview