Basic operation | Status bar
6.10.5
Auxiliary functions in Manual operation mode
Depending on the configured application mode, the following operating elements
are available:
Operating
element
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Function
Reference marks
For starting the reference mark search
Further information:
"Activating the reference mark
search", Page 115
Probing
For probing the edge of a workpiece
Further information:
"Defining presets", Page 214
Probing
For finding the centerline of a workpiece
Further information:
"Defining presets", Page 214
Probing
For finding the center point of a circular feature (hole or
cylinder)
Further information:
"Defining presets", Page 214
Presets
For setting presets
Further information:
"Presetting by probing (in the Turning
application mode)", Page 171
Tool data
For tool setting (touch-off)
Further information:
"Setting the tool (in the Turning
application mode)", Page 166
6
97