7
Minimum configuration for outputs and inputs
For operating a spindle, you must assign at least one analog output to the spindle
axis. A spindle axis can be started and stopped either via the M3/M4 M functions
or manually.
If no M3/M4 M functions are available, the spindle can be operated only manually.
To do so, you must configure the parameters of the Spindle start and Spindle
stop digital inputs. This results in the minimum configuration for the outputs and
inputs:
Control of the
spindle axis
Manually
M functions
M3/M4
120
Analog output
Spindle start
Assigned
Assigned
Assigned
Not connected
Commissioning | Steps for commissioning
Inputs
Spindle stop
Assigned
Not connected
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018