HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 265

Turning – Program run | Using the program
Depiction as contour view
The simulation window displays a contour view. The contour view provides the
necessary feedback for precisely positioning the tool or for following a contour
along the machining plane.
The contour view uses the following colors (defaults):
Figure 74: Simulation window with contour view
1 Machining pattern (white)
2 Current block or machining position (green)
3 Tool contour, tool position and tool track
(orange)
You can modify the colors and line thicknesses used in the contour
view.
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
2 1
3
"Simulation window", Page 307
16
265