20
Parameter
Digits before the decimal point
for size-adjusted axis display
Simulation window
Radial machining axes
306
Explanation
The number of integer places indicates the size at which the
position values are displayed. If the number of integer values is
exceeded, then the display is reduced in size so that the integers
can be shown.
Setting range: 0 ... 6
Default value: 3
Configuration of the simulation window for MDI mode and
program run.
Further information:
"Simulation window", Page 307
Display of the radial machining axes in the Turning application
mode
Settings:
Radius
Diameter
Default value: Radius
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | General