Adding M Functions; Configuring M Functions; 20.6.10 Special Settings - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

20

Adding M functions

20.6.8
Path:
Parameters
Name
20.6.9

Configuring M functions

Path:
Parameters
Name
Digital output
Remove

20.6.10 Special settings

Path:
Parameters
Electronic axis clamping on axis
halt
Only single axis movement via
jog buttons
Maximum machine speed
330
Settings ► Axes ► General settings ► M functions ► +
Settings ► Axes ► General settings ► M functions ► M100 ... M120
Settings ► Axes ► General settings ► Special settings
Explanation
Entry of the name for the new M function
Setting range: M100 ... M120
For the configuration, see "Configuring M functions", Page 330
Explanation
Entry of the name for the M function
Setting range: M100 ... M120
Assignment of the digital output for the M function according to
pin layout
Default value: Not connected
Removal of the selected M function
Explanation
Setting for electronic axis clamping when the axis is at a stand-
still
Settings:
ON: The axis is clamped on standstill of the axis
OFF: The axis is not clamped on standstill of the axis
Default value: OFF
Definition of the axis movements that are possible with the
traverse keys
Settings:
ON: Only a single axis can be moved
OFF: Several axes can be moved simultaneously
Default value: OFF
Definition of the maximum speed at which NC-controlled axes
can be moved
Setting range: 100 mm/min ... 10000 mm/min
Default value: 2000
The Maximum machine speed cannot be exceeded,
even if a higher feed rate has been defined for
individual axes.
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Settings | Axes