HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 124

7
Adjusting an existing table of supporting points
After a table of supporting points for segmented linear error compensation has
been created, this table can then be modified as needed.
Further information:
124
Tap Settings in the main menu
Tap Axes
Select the axis
Open in the sequence
Error compensation
Segmented linear error compensation (SLEC)
Deactivate Compensation with the ON/OFF sliding switch
Tap Table of supporting points
The table lists the supporting point positions (P) and the
compensation values (D) of the individual segments
Adjust the compensation value (D) for the supporting points
Confirm the entries with RET
To switch to the previous display, tap Back
Activate Compensation with the ON/OFF sliding switch
The adjusted error compensation for the axis is applied
"Segmented linear error compensation (SLEC)", Page 338
Commissioning | Steps for commissioning
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018