Overview - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

9
9.1

Overview

This chapter describes the production of an example workpiece. While you
produce the example workpiece, this chapter leads step by step through the
product's various operating modes with use of various machining options. You
need to carry out the following machining steps for successful production of the
flange:
Machining step
Determine preset 0
Machine a through hole
Machine a rectangular pocket
Machine a fit
Determine preset 1
Machine a bolt hole circle
Machine a row of holes
Figure 35: Example workpiece
This chapter does not describe machining of the outside contour of the example
workpiece. It is presumed that the outside contour is already machined.
178
For a detailed description of the individual activities, please refer to
the chapters "Milling Manual operation", "Milling MDI mode", "Milling
Programming" and "Milling Program run".
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
Further information: "Basic operation", Page 63
Mode of operation
Manual operation
Manual operation
MDI mode
MDI mode
Manual operation
Programming and program run
Programming and program run
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Milling – Quick Start | Overview