HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 155

Setup | Single steps for setup
Configuring the network drive
You will need the following data for configuring the network drive:
Name
Server IP address or host name
Shared folder
User name
Password
Network drive options
Contact your network administrator for the correct network settings for
configuring the product.
Requirement:
available.
Further information:
Further information:
Configuring the printer
The product can print stored PDF files with a printer connected via USB or the
network. The product supports several printer models from various manufacturers.
See the product area at
printers.
If this list contains the used printer, the appropriate driver is available on the
product and you can directly configure the printer. If this is not the case, you will
need a printer-specific PPD file.
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
The product is connected to a network and a network drive is
"Connecting a network peripheral", Page 60
Tap Settings in the main menu
Tap Interfaces
Tap Network drive
Enter the network drive details
Confirm the entries with RET
Use the ON/OFF sliding switch to activate or deactivate Show
password
If required, select Network drive options
Select Authentication for encrypting the password in the
network
Configure the Mount options
Tap OK
Tap Mount
The connection to the network drive is established
"Network drive", Page 316
www.heidenhain.de
"Finding PPD files", Page 160
for a complete list of supported
8
155