Functions For The Probing Of Presets (In The Milling Application Mode) - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Milling – Manual operation | Defining presets
Functions for the probing of presets (in the Milling application
11.3.1
mode)
A wizard assists you in setting presets by probing.
The following functions are available for probing a workpiece:
Icon Function
Probe the edge of a workpiece
(one probing procedure)
Determine the centerline of a
workpiece
(two probing procedures)
Determine the center point of a
circular form (hole or cylinder)
(three probing procedures with tool,
four probing procedures with edge
finder)
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Scheme
11
215