Position Display Functions - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Basic operation | Position display
Symbol
R
+Z
1
6.9.2

Position display functions

Coupling of axes (in the Turning application mode)
In the Turning application mode, you can alternately couple the display of the Z
axis and the Zo axis. For coupled axes, the position display shows the sum of the
position values of both axes.
If the Z axis and the Zo axis have been coupled, the Program run
operating mode is disabled.
Coupling is identical for the Z axis and Zo axis. The following describes
only the coupling of the Z axis.
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Meaning
Reference mark search not performed or no reference mark
detected
Zo axis is coupled with the Z axis. Position display shows the
sum of both position values
Further information: "Coupling of axes (in the Turning applica-
tion mode)", Page 89
Z axis is coupled with the Zo axis. Position display shows the
sum of both position values
Selected gear stage of the gear spindle
Further information: "Setting the gear stage for gear spindles",
Page 91
Spindle speed cannot be achieved with selected gear stage
Select a higher gear stage
Spindle speed cannot be achieved with selected gear stage
Select a lower gear stage
The CSS (constant surface speed) spindle mode is activated
Further information: "Setting the spindle mode (in the Turning
application mode)", Page 92
If the icon is flashing, then the calculated spindle speed lies
outside of the defined speed range. The desired surface speed
cannot be attained. The spindle will continue to turn at the
maximum or minimum speed
In MDI mode and Program Run , a scaling factor is applied to
the axis
Further information: "Adjusting settings in the quick access
menu", Page 94
Axis is feedback-controlled
6
89