Overview - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

16
16.1

Overview

This chapter describes the Program Run mode of operation and how to execute a
previously created program in this mode.
Short description
In the Program Run operating mode, you use an already created program for parts
production. It is not possible to change the program in this operating mode, but
you can check it by running it in the Single Block mode.
Further information:
Executing the Program Run depends on the machine tool and the product version:
If the machine tool has NC-controlled axes and the product uses the
POSITIP 8000 NC1 software option, the parameters for positioning movements
are transferred directly to the machine tool.
The individual steps are initiated by pressing the NC START key on the machine
tool.
If the axes of the machine tool are not NC-controlled, you need to perform
the positioning movements manually by using the handwheels or the manual
direction keys.
In both cases, the wizard guides you through the individual program steps. While
running the program, you can use the optional simulation window as a graphic
positioning aid for the axes you have to move.
260
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
Further information: "Basic operation", Page 63
"In Single block mode", Page 254
Turning – Program run | Overview
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018