HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 165

Setup | Single steps for setup
Tool parameters
You can define the following parameters:
Milling appli-
cation mode
Turning
application
mode
Creating a tool
Milling application mode
Turning application mode
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
Description
Tool type
Designation that
uniquely identifies the
tool
Tool type
Designation that
uniquely identifies the
tool
Tap Tools on the status bar
The Tools dialog appears
Tap Tools on the status bar
The Tools dialog appears
Tap Open table
The Tool table dialog appears
Tap Add
Enter a name in the Tool type input field
Confirm the entry with RET
Tap the input fields one after the other, and enter the
corresponding values
Change the unit of measure in the selection menu, if required
The entered values are converted
Confirm the entry with RET
The defined tool is added to the tool table
To protect the entry for a tool from accidental changes or
deletion, tap the Lock symbol next to the tool's entry
The symbol changes and the entry is locked
Tap Close
The Tool table dialog is closed
Parameter
Diameter D Length L
Diameter of Tool length along
the tool contact the tool axis
surface
Tool coordinate X Tool coordinate Z
Tip of the tool Tip of the tool
cutting edge in cutting edge in
the Z axis the X axis
8
165